Publicidad
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
•
Remove adjustment knob and cup washer securing
seat to cardboard packing and set aside.
•
Remove seat from the cardboard packing and set seat
aside. Remove the cardboard packing and discard.
•
Place seat on seat pan so all three (3) bottom pads
are positioned over large slotted holes in pan.
•
Push down on seat to engage pads in slots and pull
seat towards rear of tractor.
•
Pivot seat and pan forward and as sem ble adjustment
knob and cup washer loosely. Do not tighten.
•
Lower seat into operating position and sit in seat.
•
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down.
•
Get off seat without moving its ad just ed position.
•
Raise seat and tighten adjustment knob securely.
SEAT
PAN
CUP WASHER
ADJUSTMENT
KNOB
ASSEMBLY
PADS
03035
Fig. 3
NOTE: You may now roll your tractor off the skid. Continue
using the instructions that follow to remove the tractor from
the skid.
WARNING: Before start ing, read, un der stand and fol-
low all in struc tions in the Op er a tion section of this man u al.
Ensure tractor is in a well-ventilated area. Ensure the area
in front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op er a tion
section for location and function of con trols)
•
Raise attachment lift lever to its highest po si tion.
•
Release parking brake by depressing clutch/brake
ped al.
•
Place gearshift lever in neutral po si tion.
•
Roll tractor forward off skid.
•
Remove banding holding the deflector shield up against
tractor.
Continue with the instructions that follow.
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at the factory
for shipping purposes. Correct tire pressure is important
for best cutting performance.
•
Reduce tire pressure to PSI shown on tires.
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly
leveled. See "TO LEVEL MOWER" in the Service and
Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replacing motion and
mower blade drive belts in the Service and Adjustments sec-
tion of this manual. Verify that the belts are routed cor rect ly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor, check to see that
the brake is operating properly. See "TO CHECK BRAKE"
in the Service and Adjustments section of this manual.
7
Publicidad
