Publicidad
STEP 10
Hammer Block
Top edges of both
parts will be flush.
Position and insert locking bolts (10) of center rear leg (Q) into edge holes of partition (C) as
shown. Be sure both parts are positioned as shown. Place the hammer block on top of leg in each
of the 3 locking bolt locations and give a firm strike to lock together. The locking bolt (10) will snap
into the locking sleeve (11).
IMPORTANT NOTICE: Once locked together, parts cannot be separated.
Note: A rubber mallet can be used in place of a hammer and hammer block.
ameriwoodhome.com
Q
C
O
17
Publicidad
