Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610933664 7-05
BACKING PAD DAMPER
Your tool is equipped with an integrated
backing pad damper ring. This damper
reduces the no-load speed, which helps
prevent accidental marking of the workpiece
surface and provides uniform finishing.
NOTE: If you notice steadily increasing no-load
speed, this indicates that the damper ring is
worn and needs to be replaced.
To replace damper ring, remove backing pad
as described in "Backing Pad Installation" and
remove worn damper ring by pulling firmly out
of locating groove. Loosen the two screws on
shroud just enough so you can separate
shroud approximately 1/4 inch. Align locating
bumps on damper ring with cut outs in shroud
and depress ring with thumbs until shroud
seats into groove completely around ring, then
tighten screws.
IMPORTANT: Ring should not have bends or
ripples when correctly seated.
(Model 1893D & 1893DVS)
Your random orbit sander uses hook-and-loop
backed accessories, which firmly grip the pad
when applied with moderate pressure. To
change the accessory, merely peel off the old
accessory, remove dust from the pad if
necessary, and press the new accessory in
place. Be sure to align the sanding disc holes
MICROFILTER DUST CANISTER —The
integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
canister should be emptied frequently during
operation.
Your tool is equipped with
!
WARNING
a dust canister, empty it
frequently, after completion of sanding
7/28/05
3:37 PM
Installing Accessories
Dust Collection
Page 8
Apply a thin film of light grease to top side of
backing pad where the damper ring makes
contact, reassemble backing pad and firmly
tighten screw.
DAMPER RING
SHROUD
with the holes in the backing pad to allow the
dust extraction system to function.
After considerable service the pad surface will
become worn, and the pad must be replaced
when it no longer offers a firm grip. If you are
experiencing premature wearout of the pad
facing, decrease the amount of pressure you
are applying during operation of the tool.
and before storing the sander. Be
extremely careful of dust disposal, materials
in fine particle form may be explosive. Do not
throw sanding dust on an open fire.
Combustion from mixture of varnishes,
lacquers, polyurethane, oil or water with dust
particles can occur if there is a static
discharge, spark introduced in the box, or
excessive heat.
-8-
BACKING
PAD
LOCATING
BUMPS ON
UNDERSIDE
OF DAMPER
RING
Publicidad
