Publicidad
Idiomas disponibles
Idiomas disponibles
3. Maintenance of the freezer
3.1 Overall
Dusts behind the freezer and on the ground shall be timely cleaned to improve
the cooling effect and energy saving.
Check the door gasket regularly to make sure there are no debris. Clean the door
gasket with a soft cloth dampened with soapy water or diluted detergent.
The interior of the frezer should be cleaned regularly to avoid odor.
Please
turn
off
container, etc.
Use a soft cloth or sponge to clean the inside of the freezer, with two
tablespoons of baking soda and a quart of warm water. Then rinse with water and
wipe clean. After cleaning, open the door and let it dry naturally before turning on
the power.
For areas that are difficult to clean in the freezer (such as gaps or corners), it is
recommended to wipe them regularly with a soft rag, soft brush, etc. and when
necessary, combined with some auxiliary tools (such as thin sticks) to ensure no
contaminants or bacterial accumulation in these areas.
Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause
odors in the interior of the freezer or contaminated food.
Clean the baskets with a soft cloth dampened with soapy water or diluted
detergent. Dry with a soft cloth or dry naturally.
Wipe the outer surface of the freezer with a soft cloth dampened with soapy
water, detergent, etc., and then wipe dry.
Do not use hard brushes, clean steel balls, wire brushes,
abrasives (such as toothpastes), organic solvents (such as
alcohol, acetone, banana oil, etc.), boiling water, acid or alkaline
items, which may damage the freezer surface and interior.
Boiling water and organic solvents such as benzene may
deform or damage plastic parts.
Do not rinse directly with water or other liquids during cleaning
to avoid short circuits or affect electrical insulation after
immersion.
Please unplug the freezer for defrost and cleaning.)
3.2 Defrost
The freezer shall be manually defrosted.
Unplug the freezer and open the freezer door, remove foods and shelving basket
before defrosting. Open the outflow hole and drainage hole, and place water
container at the outflow hole. The indoor frost will naturally melt, wipe the defrost
water with a dry, soft cloth. When the frost softens, an ice scraper may be used to
accelerate the de-icing process.
Please remove the food and put in a cool place when defrosting before removing
accessories.
the
power
before
cleaning,
remove
12
all
foods,
basket,
V.2
Publicidad
