Publicidad
Idiomas disponibles
Idiomas disponibles
A
A. Screws
B. Oven bottom
4. Remove 2 screws from the bake burner.
5. Slide the front of the bake burner to the side to remove
tab from front of oven. Lift the back of the bake burner off
the oven orifice and set the bake burner aside. Do not
disconnect the wire.
A. Bake burner
B. Screws
A. Oven orifice
6. Apply masking tape to the end of a
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice
spud and remove by turning the Propane gas bake burner
orifice spud counterclockwise to remove. The spud will be
stamped with a "56."
7. Replace the "56" spud with a "47" spud. Install the Natural
gas bake burner orifice spud, turning it clockwise until snug.
IMPORTANT: Do not overtighten.
A. Orifice spud
8. Position the back of the bake burner over the oven orifice,
B
9. Reattach the bake burner with 2 screws.
10.
11.
1. Remove 1 screw from the broil burner.
2. Remove the flame spreader.
3. Remove the broil burner from the broil burner orifice hood.
A
B
A
4. Apply masking tape to the end of a
3
/
" (1 cm) nut driver
8
5. Replace the "100" hood with a "155" hood. Install the
A
and then align the holes for the screws.
Position the front of the oven bottom panel toward
the front frame, and then lower the rear of the oven bottom
panel into the oven.
Reattach the oven bottom panel with 2 screws and
2 washers.
To Convert Oven Broil Burner (Propane Gas
to Natural Gas) (on some models)
NOTE: The broil burner will hang in the back of the oven
while you are changing the orifice hood.
A
B
D
A. Broil burner
B. Flame spreader
C. Screws
D. Orifice hood
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice
spud and remove by turning the Propane gas broil burner
orifice hood counterclockwise to remove. The hood will be
stamped with a "100."
Natural gas broiler burner orifice hood, turning it clockwise
until snug.
IMPORTANT: Do not overtighten.
A. Orifice hood
C
3
/
" (1 cm) nut driver
8
A
19
Publicidad
