Magneti Marelli 007950016040 Manuel D'iNstructions página 3

HYDRA-KRIMP
PRE-OPERATION SET-
• Open the relief valve to
tightly.
• Rotate the yoke fully
adapter seat.
• READY TO GO!
OPERATING
WARNING: DO NOT
hose and fitting in place
to the tool. BE CAREFUL not to place hands near any pinch point while using the tool!
1. Remove pin and "Open" top yoke.
*Note: It may be necessary to turn body counter clockwise until top yoke can be rotated away
2. Select correct die set. (Either measure or get the information from the manufacturer.)
*Note: Be sure to use correct size die set! Failure to do so could cause leakage or failure of the
3. Insert dies into yoke.
4. Position fitting and hose in crimper and close top yoke.
5. Insert pin securely
*Note: Make sure pin snaps into place and
process is started.
6. a. Turn body of tool clockwise until dies are
b. Now turn pump body counter-clockwise (2-
space between yoke edge and
may cause damage to pump body.
7. Turn hydraulic valve to "closed" position.
8. Pump handle to crimp fitting onto hose.
comes to a stop.
*Note: Place the body of the tool against a solid
during the crimping
9. Once crimp is complete, turn hydraulic valve to "OPEN" position.
10. Turn body of tool counter clockwise until top yoke can be rotated away from piston portion of yoke.
11. Remove holding pin and open yoke.
12. Remove hose assembly.
Die Set
Top Yoke
rim of
process.
Magneti Marelli Aftermarket Spółka z.o.o.
Plac Pod Lipami 5, 40-476 Katowice
Tel.: + 48 (032) 6036107, Faks: + 48 (032) 603-61-08
e-mail:
www.magnetimarelli-checkstar.pl
Handle
Valve
Piston
Yoke
body to create more leverage
checkstar@magnetimarelli.com
UP
fully recess the piston. Then, close
Body
counter clockwise to bottom out the
INSTRUCTIONS
actuate the piston without having a
to crimp. This could cause damage
is secure before crimping
snug against hose fitting.
3 turns)
pump body. Failure to observe this
Continue pumping until handle
from piston.
crimp!
to create ca. 2 mm