Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
4
Removing the protective caps
□
Loosen the anges (M) from the valve bodys
(N & O). Adjust the rubber washers (P), metal
washers (Q) and mounting nuts (R) to the
bottom of valve bodys (N & O).
M
N
P
Q
R
6
Connecting the hoses
□
Connect the hoses (S) to the bottom of the hot
and cold end valves (N & O), as shown.
□
Align the middle body (F) in a position that will
allow maximum clearance to connect the
hoses (S).
□
Carefully bend the hoses (S) to t in the
available space, and carefully thread the hose
(S) couplings onto the sides of the middle
body (F). Tighten all connections with a wrench.
M
O
P
Q
R
5
Installing the valve bodies
NOTE: The hot end valve is identi ed with a label.
□
From underneath the deck, insert the cold end
valve (O) with the rubber washer (P), metal
washer (Q) and mounting nut (R) through
the hole on the right (cold) side.
□
From above, thread the ange (M) onto the
valve body (O).
□
Tighten the mounting nut (R) using a basin
wrench, so that the ange (M) sits ush against
the nished deck surface.
□
Repeat this procedure for the hot end valve (N)
on the left (hot) side.
N
N
S
5
Please contact 1-855-HD-GLACIER for further assistance.
M
O
P
Q
R
F
O
S
HOMEDEPOT.COM
Publicidad
