Publicidad
Idiomas disponibles
Idiomas disponibles
Do not force the power tool.
•
which it is designed. forcing the tool could possibly damage the tool and may result in personal injury.
Use the correct power tool for the job
•
which it is not designed.
Do not use tool if switch does not turn it on or off.
•
with the switch is dangerous and must be repaired or replaced by an authorized service center.
Turn power tool off, and disconnect the plug
•
from the power tool before making any adjustments, changing the accessories, or storing the tools. Such
preventive safety measures reduce the risk of an accidental start up which may cause personal injury.
Store idle tool out of reach of children and other inexperienced persons
•
dangerous in the hand of untrained users.
Maintain power tools with care
•
component breaks, and any other conditions that may affect the tool's operation. A guard or any other part that
is damaged must be properly repaired or replaced by an authorized service center to avoid risk of personal
injury.
Use recommended accessories
•
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury to
the user. Consult the operator's manual for recommended accessories.
Keep cutting tools sharp and clean
•
are less likely to bind and are easier to control.
Feed the workpiece in the correct direction and speed.
•
blade, against the direction of the cutting tool's direction of rotation only. Incorrectly feeding the workpiece in
the same direction may cause the workpiece to be thrown out at high speed.
Never leave the tool running unattended, turn the power off
•
until it comes to a complete stop.
•
Never start the power tool when any rotating component is in contact with
the workpiece.
WArNING:
USE OF THIS TOOL CAN GENErATE AND DISBUrSE DEBrIS,
DUST Or OTHEr AIrBOrNE PArTICLES, INCLUDING METAL CHIPS, WOOD DUST,
CrYSTALLINE SILICA DUST AND ASBESTOS. Direct particles away from face and body. Always
operate tool in a well-ventilated area and provide for proper dust removal. use dust collection system wherever
possible. exposure to the dust may cause serious and permanent respiratory or other injury, including silicosis
(a serious lung disease), cancer, and death. Avoid breathing the dust, and avoid prolonged contact with the dust.
Allowing dust to get into your mouth or eyes, or lay on your skin may promote absorption of harmful material.
Always use properly fitting NIOSH/OSHA approved respiratory protection appropriate for dust exposure, and wash
exposed areas with soap and water.
SERVICE
• Have your power tool serviced by a qualified repair person using
replacement parts. This will ensure that the safety of the power tool is maintained.
Service your power tool periodically
•
portion of the tool since internal wires may be misplaced or pinched.
SAVE THESE INSTRUCTIONS
EXTENSION COrDS
Grounded tools require a three wire extension cord
use either a two or three wire extension cord. As the distance from the power supply outlet increases, you must
use a heavier gauge extension cord. using extension cords with inadequately sized wire causes a serious drop
in voltage, resulting in loss of power and possible tool damage. Refer to the table shown below to determine the
5.8A, 4-3/4" Dry Cut Metal Saw
Operator's Manual
All manuals and user guides at all-guides.com
The tool will perform the job better and safer at the feed rate for
. Don't force the tool or attachment to do a job for
. Check for proper alignment and binding of moving parts,
. using accessories and attachments not recommended by the
. Properly maintained cutting tools with sharp cutting edges
. When cleaning a tool, be careful not to disassemble any
GMCS547C
Any tool that cannot be controlled
from the power source and/or battery pack
feed the workpiece into the
. Do not leave the tool
only identical
.
Double insulated tools can
. It is
Publicidad
