Defort DSG-400 Instrucciones De Servicio página 8

- SWITCH OFF WHEN NOT SPRAYING - Avoid run-
ning the unit with the fl ow rate knob fully closed for
any length of time.
GB
We accept no responsibility for damage caused by
the use of unsuitable substances, or paints that hare
not been thinned correctly, and any health hazards
that arise from lack of adequate ventilation
IMMEDIATELY SWITCH OFF THE SPRAY
GUNWHEN:
• Interruption in the mains plug, mains lead or mains
lead damage.
• Defectswitch.
• Smoke or stench of scorched isolation.
OPERATION INSTRUCTIONS
PREPARATION
Do not use textured wall paints or coatings as
this wHIblock the nozzle.
To obtain the best results, it is important that you pre-
pare the surface to be sprayed and thin the paint to
the correct viscosity, before you operate your spray
gun. Always ensure that the surfaces to be sprayed
are free from dust, dirt and grease. Make sure that you
have masked the areas that should not be sprayed,
using a good quality masking tape. The paint or fl uid
to be sprayed should be thoroughly mixed and free
from lumps or other particles. Many substances can
be sprayed with your spray gun, but always check the
manufacturers recommendations before purchasingy-
our paint.
THINNING
Always rememberto disconnect from the
mains sup-ply before fi lling the paint contain-
er with sprayable material.
Most paints are supplied ready for brush application
and will need to be thinned before they are suitable to
be sprayed. Follow the manufacturers advice on thin-
ning the paint when used with a spray gun. The viscos-
ity cup will help you to determine the correct viscosity of
paint to be used. To determine the correct viscosity, fi ll
the cup to the brim with the paint. Measure the amount
of time it takes for the cup to empty back into the can.
The table below shows recommended times for differ-
ent types of material.
8
B
Plastic & latex paint
Water based paint
Primers
Varnishes
Oil based paints
Enamel paints
Aluminium paints
Carundersealing
Wood sealers
Wood preservatives
Wood stains
If the paint takes longer than the recommended time to
empty, then further thinning is required. Mix in a small
quantity of the appropriate thinner and use the viscos-
ity test until the correct thickness is achieved. Some
sprayable materials contain particles and lumps. These
materials should be strained before fi lling the paint con-
tainer.
SPRAYING C
Fill the paint container with the correctly thinned
and strained paint. Connect the spray gun to the
mains supply. Aim the spray gun at a piece of
scrap material and operate the trigger switch until
paint is spraying. Adjust the output control
until the required volume of paint is spraying.
SPRAYING TECHNIQUES
To obtain the best results, keep your spray gun level
and parallel to the surface at all times.
Keep the nozzle 25 - 30 cm from the surface and spray
evenly from side to side or up and down. Do not spray
at an angle as this will lead to paint runs on the surface.
Use smooth and even strokes. When spraying large
areas, use a criss-cross pattern as shown.
24 - 28 seconds
20-25 seconds
24-28 seconds
20-25 seconds
18-22seconds
18-22seconds
22-25 seconds
25-35 seconds
28-35 seconds
Nothinningrequired
Nothinningrequired
D