A.
B.
D.
E.
F.
CAPABILITIES
Will shred: Paper, plastic credit cards*, staples* and small paper clips*
*Manual Feed
Will not shred: Adhesive labels, CD/DVDs, continuous form paper, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than
noted above
Paper shred size:
Micro-Cut ...................................................................... 5/32 in. x 1/2 in. (4mmx12mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
instruction manual. Read the entire instruction manual before operating
shredders.
paper entry. Always set to off or unplug when not in use
shredder openings. If object enters top opening, switch to Reverse (
to back out object.
or near shredder. DO NOT USE "CANNED AIR" OR "AIR DUSTERS" ON
SHREDDER. Vapors from propellants and petroleum based lubricants may
combust causing serious injury.
place near or over heat source or water.
2
C.
KEY FEATURES AND CONTROLS
G.
A. Auto Feed Tray
H.
B. Auto Feed Access Panel
C. Disconnect Power Switch
1. OFF
2. ON
D. Manual Feed Slot
E. Pull-Out Bin
F. Casters
Maximum:
Sheets per pass (Auto Feed) ....................................................................................... 100*
Sheets per pass (Manual Feed) .................................................................................... 10*
Cards per pass ............................................................................................................... 1*
Paper entry width .....................................................................................8.7 in. (220mm)
* 8.5 in. x 11 in., 20lb., (75g) paper at 120V/60 Hz, 3.5Amps; heavier paper, humidity
or other than rated voltage may reduce capacity. Recommended daily usage rates:
600 sheets; 10 credit cards.
position to operate shredder. In case of emergency, move switch to OFF ( )
position. This action will stop shredder immediately.
the voltage and amperage designated on the label. The grounded outlet or
socket must be installed near the equipment and easily accessible. Energy
converters, transformers, or extension cords should not be used with this product.
)
ENGLISH
Model 100MA
G. See Safety Instructions
H. Control Panel and LEDs
1. Reverse
2. Start (blue)
3. Bin Open
4. Remove Paper (red)
5. Bin Full (red)
6. Overheat (red)