Descargar Imprimir esta página

BoomToneDJ ROBO WASH7X12W Manual De Instrucciones página 6

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Setting Reversed or Normal LED Display
Press the "MODE/ESC" button and choose "d.s"(normal) or "rd.s"(reversed). "UP" and "DOWN" buttons cycle
between the two settings. Press the "ENTER" button to confirm the selection b-Auto Run Mode
One of two Auto Run Sub-modes can be selected with a choice of preset speeds .This mode enables the unit to act as
a Master to other Slave units
Choosing Auto Run Sub-modes
Press the "MODE/ESC" button to display "NAFA" or "NASL". "UP" and "DOWN" buttons change between the two
initial options. With the appropriated option selected, use "ENTER" to confirm and the LED Display will change to:
"Fast" (fast) or "SloU" (slow). The unit will then run at the selected speed
Initial LED Display
NAFA
NAFL
c-Sound Activated Mode
The unit responds to sounds picked up by the built-in microphone to create a light show. The sound changes
the color and the position of the effect. This mode enables the unit to act a Master to other Slave units
Selection of Sound Activated mode
Press the "MODE/ESC" button and choose "NStS". When the "ENTER" button is pressed the LED Display changes to
"SrUn" and the unit enters Sound Activated Mode.
Initial LED Display
NStS
d- Slave Mode
Up-to 32 units can be daisy chained together with one single unit acting as Master and all other linked units acting as
Slaves. Slave units will all run in sync with the master unit without the need for an additional controller. Connections
can be made using standard DMX control cables with Master unit running in Auto Run or Sound Activated Modes
and placed at the beginning of the chain
Selection of Slave Mode
Press the "MODE/ESC" button and choose "SLAu". When the "ENTER" button is pressed, the LED display changes to
"Son" and the unit will be slaved to control signals coming from a Master unit e-
Service Modes
After major configuration changes, it may be necessary to reboot or reset the unit.
Resetting the Unit
Press the "MODE/ESC" button and choose "rEST"(restore). Press "ENTER" to confirm. The unit powers itself down
and then on again for a few seconds. During this time, the LED display will scroll "rEST" from left to right, after which
normal operation recommences.
MSC Distribution 2021
Second LED Display
Fast
SloU
Second LED Display
SrUn
Sub-mode
Fast Auto Run
Slow Auto Run
Sub-mode
Sound Activated
Page 6

Publicidad

loading