Publicidad
Idiomas disponibles
Idiomas disponibles
12
USING THE G1100
USER INTERFACE
MODE BUTTON
ERROR LED
The MODE button
The ERROR LED
(Orange) will illuminate
is used to select
when an error condition,
the charging modes
or reverse polarity, is
manually.
present.
6V NORM LED
6V COLD/AGM LED
Charge mode for
Charge mode for 6V
6V Wet, Gel and MF
batteries below 32°F (0°C)
batteries.
and AGM batteries.
WICKED SMART FEATURE
ERROR CONDITION. An ERROR condition could happen for multiple
reasons. If an ERROR condition occurs, the ERROR LED and CHARGE
LEDs (25%, 50%, 75%, 100%) will blink "on" and "off" at 5Hz. For
assistance in resolving ERROR's, see the section entitled, TROUBLE
SHOOTING.
Now That's Smart, Wicked Smart.™
CHARGE LEVEL
STANDBY LED
The STANDBY LED
Indicates the current
(Green) illuminates
charge level of the
when a charging
battery.
mode has not been
selected.
12V NORM LED
12V COLD/AGM LED
Charge mode for
Charge mode for 12V
12V Wet, Gel and MF
batteries below 32°F (0°C)
batteries.
and AGM batteries.
HOW TO START CHARGING
1.) Confirm that you have connected the battery clamp or eyelet terminal
connectors properly and the AC power plug is plugged into an electrical
outlet.
2.) The battery charger will begin in the STANDBY mode, indicated by a Green
LED. In the STANDBY mode, the battery charger is not outputting any current.
By pressing the MODE button, toggle to the appropriate charge mode, either
6V NORM, 6V COLD/AGM, 12V NORM, or 12V COLD/AGM, depending on the
chemistry of your battery, to begin the charging process.
3.) Depending on the charge mode selected, a Red (for NORM) or Blue (for
COLD/AGM) LED will illuminate the selected charge mode and the CHARGE
LEDs (25%, 50%, 75%, 100%) will begin to illuminate (depending on the
health of the battery), indicating the charging process has started.
4.) When the battery is fully charged, all the CHARGE LEDs will be a solid
color (Red, Red, Yellow, Green), indicating the charge process is completed.
5.) The battery charger can be left connected to the battery at all times to
provide maintenance charging. However, it is good practice to check the
battery periodically.
WICKED SMART FEATURE
INITIALIZATION. When the battery charger is plugged into an AC
electrical outlet and connected to a battery, there will be a brief (one- to
three-second) delay, then all LEDs will light up for a half (1/2) second,
to confirm all LEDs are operational. After the initialization, the only LED
that will illuminate is the last mode selected. If not in STANDBY mode,
the battery charger will begin charging after five (5) seconds. The five (5)
second delay allows time to toggle through the charge modes.
Now That's Smart, Wicked Smart.™
USING THE G1100
G1100
geniuschargers.com
13
Publicidad
