Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
WARNING
WARNING
WARNING
- Before operating always check fan for loose
or damaged parts. Inspect power cord for any
damage. Never use fan if any parts are
damaged or missing. Never use fan without
safety guards attached.
- Operate only on 120 volt 60 Hz (cycle) current
with a minimum of a 15 amp circuit.
20" Floor Fan
20REM-F
4002234
Adjusting Fan Tilt: To adjust the tilt angle, use supplied
knob wrench to loosen the adjustment screw. After
adjustment, retighten the adjustment screw. Save knob
wrench for future use.
© 2020, Pinnacle Climate Technologies, Inc.
NEVER LEAVE A FAN UNATTENDED WHILE OPERATING
OR WHILE CONNECTED TO A POWER SOURCE
To Reduce The Risk Of Electric Shock, Do Not Expose To Water Or Rain.
This unit is designed for indoor use only.
Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and regulations.
When servicing or replacing a component requires the removal or
disconnection of a safety device, the safety device is to be reinstalled or
remounted as previously installed before operating this fan.
Use this fan only in the manner intended by the manufacturer. If you have
any questions, contact Customer Service at 800-641-6996.
- When used with an extension cord, use only a
cord of proper size (Amp rating), UL listed, and
with receptacle to accept three prong grounded
plug furnished on the fan's power cord. Always
keep power cord and extension cords away
from heat, oil, and sharp edges. Inspect cords
periodically and replace if damaged.
Installation and Assembly
1.Align cradle base with support brackets
attached to fan body sides. Note: you may need
to flex the parts to make them align properly.
2.Insert support bracket into opening of cradle
base. Press spring loaded button down to allow
it to insert into cradle base, see Fig.1.
3.Press support bracket into cradle base until
spring button protrudes out open hole in cradle
base, see Fig. 2.
4. Repeat above process for opposite side of fan.
Fig. 1
2
Fig. 2
Spring
Button
Cradle
Base
High Velocity Fan User's Manual
Support
Bracket
Spring
Button
Publicidad
