Truper DES-30C Instructivo página 21

Assembly
Shaft
• Align the safety pin (a) of the lower shaft with the
middle hole in the clamp (b).
• Press the safety pin down and insert the lower shaft into
the clamp.
• Release the safety pin; ensure that it engages in the hole
on the upper shaft .
• Tighten the locking knob anticlockwise to secure the
connection (c).
b
a
Cutting string replacement and mounting
• With the string trimmer turned off, remove the
spool-retaining cap (A) turning counter-clockwise.
• Remove the empty spool. Verify it is clean and has no
damaged or worn parts.
• Cut 20´ length of cutting line. Make a loop in the middle
of the line and insert the loop in the spool inner hook
(B). Hold the line and wind it clockwise. Double-check each
end of the line is wound in its respective section (upper and
lower). Do not wind too much line. After winding there
shall remain a 0.2" minimum distance between the spool
edge and the wound line.
• Leave approximate 6" unwound on both ends of the
line and insert each one of them in the spool notches (C).
This is to prevent the line to unwind while installing the
spool in the brush cutter. Later on you will release the
lines from their notches.
• Set back the spool in its cover passing the ends of each
line through the cover orifices (D). If the line is loose or
tangled in this step, wind it again in the spool and secure it
in its notches.
• Set the spool cover in the axis (E) and secure the spool
tightening the retention cap (A).
• Apply force and pull both ends of the cutting line
outwards to release it from the notches in the upper side
of the spool (G).
Auxiliary handle
• Install the auxiliary handle as shown in the figure.
• To operate comfortably move the auxiliary handle
trough the string trimmer arm up to the right height.
• Tighten the screws to fix into position.
c
Harness
• Set the harness in the handle ring to support the string
trimmer on the shoulder.
1
C
B
C
G
Notch
release
ENGLISH
2
E
D
A
7