Sharp SJ-BA05DTXK2-EU Manual De Uso página 12

CHAPTER -6: TROUBLESHOOTING
There is a build-up of humidity inside the fridge
Check if:
• All food is packed properly. Containers must be dry before being placed in the fridge.
• The fridge doors are opened frequently. Humidity of the room will enter the fridge each time the doors are
opened. Humidity increases faster if the doors are opened frequently, especially if the humidity of the room is
high.
• There is a build-up of water droplets on the rear wall. This is normal after automatic defrosting (in Static Models).
The doors are not opening or closing properly
Check if:
• There is food or packaging preventing the door from closing
• The door compartments, shelves and drawers are placed properly
• The door gaskets are broken or torn
• Your fridge is level.
The edges of the fridge in contact with the door joint are warm
Especially during summer (warm weather), the surfaces in contact with the door joint may become warmer during
operation of the compressor. This is normal.
Important Notes:
• In the case of a power failure, or if the appliance is unplugged and plugged in again, the gas in the cooling
system of your refrigerator will destabilise, causing the compressor protective thermal element to open. Your
refrigerator will start to operate normally after 5 minutes.
• If the appliance will not be used for a long period of time (such as during holidays), disconnect the plug. Defrost
and clean the refrigerator, leaving the door open to prevent the formation of mildew and odour.
• If the problem persists after you have followed all the instructions above, please consult the nearest Authorised
Service Centre.
• This appliance is designed for domestic use and for the stated purposes only. It is not suitable for commercial
or common use. If the consumer uses the appliance in a way that does not comply with these instructions,
we emphasise that the manufacturer and the dealer will not be responsible for any repair or failure within the
guarantee period.
CHAPTER -7: TIPS FOR SAVING ENERGY
1. Always allow foodstuffs to cool before storing in the appliance.
2. Thaw food in the fridge compartment, this helps save energy.
3. Energy consumption of your appliance is declared without
drawers and fully loaded in freezer compartmant.
4. For saving energy, do not use volume between the load limit and
the door, along the load limit line. Load limit line is also used in
energy consumption declaration.
EN -11-