Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
(ref. Fig. 1)
1. Before using this product, read the operator's manual
completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards
associated with its use.
2. Verify that the product and application are compatible,
if in doubt call Customer Service (888) 332-6419.
3. To familiarize yourself with basic operation, place
Hydraulic Unit in an upright, level position then turn
Release Knob:
a. Clockwise until firm resistance is felt to further
turning. This is the 'CLOSED' release valve position
used to raise the ram plunger.
!
WARNING
• Study, understand and follow all instructions before
operating this device.
• Use of this product is limited to lifting, lowering and
holding loads consisting of a single vehicle whose
lifting points are compatible with the lifting platform.
Incompatibility is evident when the loaded vehicle
wobbles, appears unstable, and/or does not secure-
ly engage the lift platform.
• Do not exceed rated capacity.
• Use only on hard, level surfaces.
• Center load on lift platform.
• Immediately after lifting load, ensure Height Locking
Lever is engaged.
• Engage locking caster mechanism before working
on or around loaded lift. Do not move or dolly load
supported by this device.
• Restraining an incompatible load will not make the
load secure and may cause unexpected loss of
load.
• Never work on, around or under a load that is not
secured and stable.
• Keep operator's and bystander's head, hands and
feet away from lift arms when raising and lowering.
• No alterations shall be made to this product.
• Failure to heed this warning may result in personal
injury and/or property damage.
b. Counter-clockwise, but no more than 1/2 turn from
the closed position. This is the 'OPEN' release valve
position used to lower the ram plunger.
4. With Ram fully retracted and release valve closed,
pump Lift Pedal. If Ram responds immediately, bottle
jack is ready for use. If not, follow Bleeding/Venting
Trapped Air procedure, pg. 4. Ensure the oil level is
just below the oil filler hole.
5. Pour a teaspoon of good quality, air tool lubricant into
the air supply inlet of the lift control valve. Connect
to air supply and operate for 3 seconds to evenly
distribute lubricant.
Release Knob
Guide
Release Knob
attachment point
Figure 2 - Hydraulic Unit assembly
3
Ram Pin with
cotter pin
M8 Allen
Bolt
Publicidad
