Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
TROUBLESHOOTING & WARRANTY
SYMPTOMS
Washer will not
operate
Page 30
POSSIBLE CAUSE
Water supply is turned
off . Control panel has
powered off due to
inactivity. Washer is
unplugged. Controls are
not set properly.
Lid is open.
Circuit breaker/fuse is
tripped/blown.
Control needs to be
reset.
START/PAUSE was not
pressed after a cycle
was set.
Extremely low water
pressure.
Washer is too cold.
Washer is running under
Delay start program.
SOLUTIONS
This is normal. Press the POWER
button to turn the washer on.
Make sure cord is plugged securely
into a working outlet.
Turn both hot and cold faucets fully
on.
Make sure the cycle was set
correctly, close the lid and press the
START/PAUSE button.
The washer will not operate if the
lid is open. Close the lid and make
sure that nothing is caught under
the lid preventing it from closing
completely.
Check house circuit breakers/fuses.
Replace fuses or reset breaker. The
washer should be on a dedicated
branch circuit. The washer will
resume the cycle where it stopped
once power is restored.
Press the POWER button, then re-
select the desired cycle and press
the START/PAUSE button.
Press the POWER button then re-
select the desired cycle and press
the START/PAUSE button. The
washer will shut off if the START/
PAUSE button is not pressed within
ten minutes.
Check another faucet in the house
to make sure that household water
pressure is adequate.
If the washer has been exposed to
temperatures below freezing for
an extended period of time, allow
it to warm up before pressing the
POWER button. Otherwise, the
display will not come on.
It's normal if the unit doesn't operate
under Delay start function. It will
start automatically after the delay
time is out.
Publicidad
