Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Operating Instructions
Remote control
The remote control and control panel will look like one of the following pictures.
2
7
4
1. POWER BUTTON
To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
This button takes priority over any other buttons.
2. OPERATION MODE SELECTION BUTTON
Everytime you push this button, it will toggle COOL, FAN and HEAT.
3. ON/OFF TIMER BUTTON
Everytime you push this button, timer is set as follows.(1Hour ➔ 2Hours ➔ 3Hours ➔ 4Hours ➔ 5Hours
➔ 6Hours ➔ 7Hours ➔ 8Hours ➔ 9Hours ➔ 10Hours ➔ 11Hours ➔ 12Hours ➔ Cancel)
4. FAN SPEED SELECTOR
Everytime you push this button, it is set as follows. (Hi[
5. ROOM TEMPERATURE SETTING BUTTON
This button can automatically control the temperature of the room. The temperature can be set within a
range of 60°F to 86°F by 1°F.
6. AUTO SWING
This button can automatically control the air flow direction.
7. ENERGY SAVER
The fan stops when the compressor stops cooling.
Approximately every 3 munutes the fan will turn on and check the room air to determine if cooling is needed.
8. REMOCON SIGNAL RECEIVER
A slight heat odor may come from the unit when first switching to HEAT after the cooling
season is over. This odor, caused by fine dust particles on the heater, will disappear quickly.
AUTO RESTART
When power is restored after an electrical power failure, the unit will begin to run at its last setting.
16 Room Air Conditioner
3
5
6
REMOTE CONTROLLER
8
5
1
3
7
] ➔ Low[
] ➔ Hi[
Power
1
Temp
Fan Speed
4
Timer
Mode
2
Energy
Auto
Saver
Swing
6
]....)
Publicidad
