NeuLog NUL-225 Guia Del Usuario página 19

Reset to zero
The force plate sensor comes pre-calibrated however,
after use you may find that the sensor is slightly off or
you may want to run an experiment that requires zeroing
the sensor with a constant applied force to it.
To zero the sensor:
1. Connect the NUL-225 force plate sensor to a
computer/tablet/smart device following one of the
guides below.
2. Open the NeuLog application.
3. When your sensor has been detected click on the
force plate module box (on the left side of your
screen).
4. Click on the 'Extra command' button.
5. Remove all weight from the sensor and click reset to
zero your force plate sensor.
6. Your force plate sensor is now reset to zero.
Note: You can zero the scale with a constant force being
applied to it to set that value as your new "zero". This is
also used to eliminate the "Tare".
V2018.01
19
Home
English