Zeegma Zonder Pro Compact Manual De Usuario página 10

5. Suck up residual water and detergent from cleaned surfaces. If necessary, repeat
EN
the activity.
Note! If the tank overflows or the device overturns with water inside, immediately turn
off the device and disconnect it from the power source due to the risk of damaging
the motor. Overfilling of the tank will signal the characteristic sound of a clogged
passage combined with a decrease in the suction power of the device.
TROUBLESHOOTING
Problem
Dirt / water escapes from
the telescopic tube.
Weak suction.
The device makes
unusual sounds.
Smoke is coming out
of the device.
Insufficient filtering.
CLEANING AND MAINTENANCE
1. Turn off and disconnect the device from the power source
2. Release the plastic clamps (9, fig. A) to open the upper body and pull out the dry
vacuum bag (17, fig. A) or pour out the water for wet vacuuming.
3. Clean the inside of the tank with a damp cloth and let it dry completely.
Note! If dirty, the filters should be washed under running water and allowed to dry
completely. It is recommended to change the filters regularly.
The photos are for reference only, the actual look of the products may differ from the ones
Cause
Accessories have not been
properly mounted.
The filter / telescopic tube /
hose / inlet hole is clogged.
•
Overfilled tank.
•
The device fell over and
the air inlet was blocked.
•
The device overheated
or overfilled.
•
Damaged motor.
The filter has been
used too long.
shown in the pictures.
Solution
Make sure accessories are
tightly and properly mounted.
•
Clean the filter, replace
the bag and make sure the
accessories are not clogged.
•
Check the upper body
and make sure the plastic
clamps are properly closed.
•
Remove excess water.
•
Place the device in an
upright position.
•
Turn off the device and
remove excess water. Clean
the filter and replace the bag.
•
Contact the manufacturer.
Replace the filter with a new one.