Ikegami IEN-T01P Manual De Instrucciones página 14

8. Turning on the power
This encoder has no power switch. About 10 seconds after the power is turned on, the encoder
gets started and the LED indicators start flashing. When a PC (Windows XP SP1) is hooked up
with the encoder for the first time, the encoder gets started in about 30 seconds.
9. Hooking up the PC to the encoder
To hook up the encoder directly to a PC, use a cross LAN cable.
To connect the encoder via a hub to a PC, use a straight LAN cable.
Enter the encoder's URL in the Internet Explorer address bar.
The initial setting is "http://192.168.1.100/".
A pop-up window opens and you are asked for the user name and password. Enter the
administrator's or operator's user name as well as the password, and click on
initial settings are "admin" for the administrator's user name and "1" for the password. The
operator's user name is not registered.
When the user name and password are correct, the monitor screen shows up.
* When connecting the camera to a PC for the first time, the following message appears
onscreen. Click on "Install", and ActiveX gets installed. (This message does not appear on the
second and later connections.)
(Above shown is the Windows XP SP2 screen.)
E-10
. The