Publicidad
Idiomas disponibles
Idiomas disponibles
Care • Operation • Service
READ ALL INSTRUCTIONS BEFORE USING THE HEATER
Operation – 7 step set-up for EdenPURE
1) Unpackage heater. Cut open tape area, fold back flaps remove cardboard
packaging. lift heater from box. we recommend keeping the packaging for
off-season storage and any transport needs.
2) Find a level and unobstructed location to place the unpackaged heater.
3) Plug the power cord directly into an unused grounded 110 volt 15 amp or
higher circuit receptacle. The power switch will illuminate and the heater will
beep 3 times indicating the unit is plugged into the receptacle.
4) Insert 2 "AAA" batteries into the battery compartment on the remote control.
5) Push the "Power" button located on the front of the heater or the remote control
to turn the heater on. Set the Mode Key to "Auto". Adjust the "temp up" and
"temp down" buttons until the desired temperature is reached. Once the desired
temperature is reached, the heater will cycle on and off to maintain the room tem-
perature. when the Heater is set on the "Auto" mode and cycling off and on, it
has been equipped with an Energy Savings feature. The unit will run on full
power until it gets to within 2 degrees of the desired temperature. At this point it
will automatically go into an energy savings mode which shuts down 2 of the
heating elements and lowers the fan speed. Not only will this save energy, it also
keeps the room temperature closer to the desired temperature. The fan will run
periodically to circulate the room air through the heater in order to monitor the
room temperature more accurately. If the room temperature should fall below 2
degrees of the desired temperature, the unit will return to the full power mode
until the desired temperature is reached again.
6) Switch the Mode Key to "High" in order to have the heater stay on high heat
and not cycle on and off.
7) To turn the heater off, press the "Power" button; the fan will continue to run
until all of the heat has been expelled and will then turn off.
8) The heater is equipped with a temperature limiting control contained inside the
unit. If the heater stops working, shut the power off and let the unit cool down.
Turn the power back on and resume use. If the unit continues to shut down or the
unit does not reset itself, please contact us for service.
Cabinet Care – wipe clean with a soft damp cloth.
Heater Storage – when the heater is not going to be used for an extended pe-
riod of time, please do the following:
1) Unplug Heater.
2) wind up electrical cord so as to keep it off of the ground.
3) Cover the heater to prevent dust from accumulating on filter
or internally.
4) Store the heater in a dry, low dust environment.
Service – To replace a heating element or for other repairs or service,
please call us toll-free at 1-800-219-8458.
SAVE THESE INSTRUCTIONS
US Model 1000
®
4
Publicidad
