ALTRA Flame 1859096COM Manual Del Usuario página 3

INSTALLATION INSTRUCTION
Position your completed mantel close to its final location. Make sure you can access the back of
the mantel as your electric fireplace appliance will be installed from back.
Using a Phillips head screwdriver, remove the screws and the metal mounting center opening.
Next unpack the electric fireplace appliance carefully. Position the appliance behind the fire-
place with front facing the wood mantel. With the help of an adult assistant, lift the appliance
and gently slide it into the opening in the mantel. Make sure the appliance is centered left and
right in the opening. Be careful when placing appliance and adjusting, bottom of appliance could
scratch the finish of the base/hearth of your fireplace. Re-attach the mounting brackets with the
Phillips head screwdriver, and supplied screws.
DO NOT OVER TIGHTEN. With the help of an
assistant, carefully lift completed unit and place
it with the front facing out in the final location
you have chosen for your fireplace. Make sure
to secure the electrical cord before lifting or
moving completed fireplace. When choosing a
final location, make sure you will have clear
access to grounded electrical outlet.
GROUNDING INSTRUCTIONS:
This heater is for use on 120 volts. The cord has
a plug as shown at (A) in figure 2. An adapter as
shown at (C) is available for connecting
three-blade grounding-type plugs to two-slot
receptacles. The green grounding lug extending
from the adapter must be connected to a per-
manent ground such as a properly grounded
outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
NOTE: Adapters are NOT for use in Canada
ELECTRICAL SPECIFICATIONS
Voltage: 120VAC 60Hz
Watts: 1400 Watts
ameriwoodhome.com
≥1.5"
ELECTRIC
FIREPLACE
INSERT
≥1"
≥1"
（A）
Grounding Pin
Cover of Grounded Outlet Box
Adapter
Grounding Lug
Metal Screw
Cover of Grounded Outlet Box
3
ELECTRIC
FIREPLACE
INSERT
≥1.5"
≥1"
≥1"
（B）
REAR VIEW OF FIREPLACE
Figure 2
A
B
C
You
Tube