Vonyx AP800A Manual De Instrucciones página 4

REAR PANEL
Passive speaker output connector, minimum load 8 Ohm!
TROUBLESHOOTING
One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work correctly for
the suspected problem speaker. If the "normally correct speaker" is experiencing the same difficulties or problems
as the suspected problem speaker, use the information below to isolate the problem.
Problem
No output
Intermittent
Constant noise,
buzzing and/or
humming
Poor low-
frequency output
4
Possible cause Action
Cables Reseat all connectors
Substitute known good cables
Check solder joins
Inspect cable for damage
Inspect wire or connector for stray strand that may short
Poor connections While it is possible for a faulty speaker to exhibit intermittent
output, it's more likely that an output cable/connector is the
problem. Check the soldering on your connectors.
Faulty electronic Any constant noise originates in the amplifier, mixer, signal
processing, source device in the signal devices, or line-level
wiring. Check and correct system grounding as required. Chain
check for noisy sources or electronic components. Check wiring
for shielding.
Improper polarity When two speakers in close proximity to each other are
connected out-of-polarity, they can partially cancel each other out,
especially at low frequencies. Check your speaker cables to be
sure they are all identically wired and connected. Check the
balanced line signal cables to be sure they are all correctly wired.
1. Jack ¼" input connector for microphone.
2. RCA line input connector for the audio input source e.g.
mixer, CD player, etc.
3. Volume control for the microphone.
4. Volume control for the line input.
5. Tone control.
6. Power ON/OFF LED indicator
will light when the amplifier is turned on.
This clear green indicator
.