Publicidad
Idiomas disponibles
Idiomas disponibles
pressure by depressing trigger, and disconnect power source. NEVER
assume system pressure is zero!
DO NOT ATTEMPT TO UNCLOG (BACK FLUSH) SPRAY GUN
BY SQUEEZING TRIGGER WHILE HOLDING FINGER IN
FRONT OF FLUID NOZZLE.
Pressure may vary according to viscosity of material used.
Maximum working pressure of gun is 70 psi. DO NOT
EXCEED PRESSURE LIMIT OF GUN OR ANY OTHER COMPONENT IN
SYSTEM!
Prior to daily operation, make certain that all connections
and fittings are secure. Check hose and all connections for
a weak or worn condition that could render system unsafe. All replacement
components such as hose or fittings must have a working pressure equal
to or greater than system pressure.
Before use
●
Install a moisture
separator/regulator when there
is a possibility moisture will
damage the surface to be
painted. Install the moisture
separator/regulator as close to
the tool as possible.
NOTE: Liquid water occurs
naturally in air lines as a result
of compression. The moisture
exiting near the compressor is
warm and still in a vapor state which allows it to pass through the moisture
separator. The vapor must travel a minimum of 5 to 10 feet to cool down to
a liquid to be removed by the moisture separator. See Illustration.
●
Prior to shipment, this gun was treated with an anticorrosive agent. Before
using this gun make sure that it is carefully flushed with thinner.
D28267
GENERAL INFORMATION
Before disassembly or removal of any part of gun or
attached components, shut off compressor, release
TO AVOID CREATING AN EXPLOSIVE ATMOSPHERE,
WORK ONLY IN WELL-VENTILATED AREAS.
USE OF A FACE MASK IS RECOMMENDED TO PREVENT
INHALATION OF TOXIC MATERIAL.
OPERATION
4- ENG
Publicidad
