Aurora AU-A1ZBDSS Manual De Instrucciones

MODEL AU-A1ZBDSS
DESCRIPTION 2 GANG SWITCHED SOCKET
VOLTAGE (V) 230V AC
HERTZ (HZ) 50Hz
PRODUCT RATING 0.08-13A
RESISTIVE LOAD 3000W
INDUCTIVE LOAD 3000VA
RF FREQUENCY 2.4GHz, IEEE 802.15.4
WORKING ENVIRONMENT TEMP 0°C to 40°C
WORKING ENVIRONMENT HUMIDITY ≤85% Non Condensing
ENERGY MONITORING ACCURACY Typ +/- 3.0%
PROTOCOL Zigbee HA1.2
FREQUENCY BAND 2.40-2.483Ghz
DISTANCE
30m (open field)
• For support please call the technical helpline - 01707 351 859
• Installation must be carried out in accordance with the latest edition of
the Wiring Regulations by a qualified electrician.
• Hereby, Aurora Limited declares that the radio equipment type
AU-A1ZBDSS is in compliance with Directive 2014/53/EU. The full text
of the EU declaration of conformity is available at the following internet
address:
www.auroralighting.com/ProductDetail/AU-A1ZBDSS
USING THE APP TO PAIR THE DOUBLE SOCKET WITH
YOUR PHONE
1. Download AOne UK App from your App Store
2. Follow instructions on the App to pair the double socket.
General Functions:
Please press the buttons assigned to each socket, or use the AOne UK
App to switch the sockets on and off.
The LED ring around the button will light up Blue when the socket is ON.
The LED ring around the button will light up Red when the socket is OFF.
(The LED ring can be disabled for the OFF state through the AOne UK App)
REMOVE EXISTING 2 GANG SWITCHED SOCKET
1 2
WIRE AND INSTALL THE AONE ZIGBEE DOUBLE SOCKET
6
Important information: The fixing screws are not earthed, please ensure that this socket is wired correctly.
Connect to earth terminal in the back box
Current UK wiring colours are as follows:
Green/Yellow = Earth
Brown = Live
Blue = Neutral
8
When moving socket into the backbox ensure that none of the
cables are trapped or damaged.
8A Suitable for 35mm back box 10mm Spacer included for 25mm back box
8B
www.auroralighting.com
3
7
Important information: If the back box has
an earth terminal please add a piece of
earth cable from one of the socket earth
terminals to this terminal.
9
Screws and caps included on inside
of front plate.
Ensure screws are fully tightened.
Leave existing wiring
4
Ensure backbox
has a minimum
depth of 25mm
10
Document Version: AU-A1ZBDSS_V1_18