Manta UCH003 Manual De Usuario página 4

Hardware kit:
A (×4) M5×16 Screw
B (×4) M6×16 Screw
C (×4) M8×16 Screw
Step1: Wall plate installation
Wood Stud Installation
NOTE :For secure wood stud mounting,the wall plate must be mounted to two studs at
least 16"apart.
Use a high-quality electrnic stud finder (commercially available) to locate two adjacent studs
1
and mark their locations with a pencil.
2
With the help of an assistant, and using the bubble level to ensure the wall plate is level, position the wal
l plate against the wall in the desired mounting location.
3
Mark the right (upper and lower) and the left (upper and lower) positions of the small horizontal slots that are in
alignment with the studs.
4
You should mark four positions total.
5
Next, Pre-drill a 5mm hole 50mm deepth in the wall stud at each marked location.
6
please position the wall plate against the wall and line up the mounting slots with drilled holes
7
For each location, insert a lag bolt and washer(J) into the wall
8
Tighten bolt with an open ended socket wrench by turning clockwise until tight.
Do not over-tighten bolts-doing so many cause unnecessary damage to the wall.
CAUTION:
Avoid excessive torque.
CAUTION:
Do not release the wall plate until it is properly mounted and secured to the wall.
Concrete/Brick Installation
NOTE: The concrete anchors must be used for concrete installation.
1
Begin by placing the wall plate into position against the wall, using the bubble level to keep it level.
2
Mark off four holes to be used for securing the mount and place the wall
3
Next,drill holes using an electric drill and 12mm masonry bit 50mm deepth.
Insert a concrete anchor into to rach hole.
4
If necessary, a hammer can be used to liahtly tap each anchor into place so that they are flush with the
5
wall.
Once all of the anchors are in place ,move the wall plate back into position .
6
Attach the bolt into the washer(G) that is placed in the wall .
7
8
Do not tighten until all screws are in plate .
User's Manual
D
E
F
G
4
(×4) M8/M6/M5 Washer
(×4) M8 Bolt
(×4) M8Concrete anchor
(×4 ) M8 Washer
E N