Publicidad
Idiomas disponibles
Idiomas disponibles
Installing Universal Adapter Plate to Display
• Tighten screws so display brackets are fi rmly attached to display. Do not tighten with excessive force.
Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing
screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display.
6
Place display face side down and refer to display manufacturer's instructions for removing obstructions from the
back of the display. Adjust display brackets of universal adapter plate (B) to align with display mounting holes.
Select the screws from the baffl ed fastener pack that best fi t your display and secure to display following step 6-1
or 6-2 on page 9.
NOTE: Top and bottom mounting holes must be used for attaching display brackets.
Verify that all holes are properly aligned, then tighten screws using a phillips screwdriver.
DISPLAY
B
DISPLAY BRACKETS
CENTER DISPLAY BRACKETS VERTICALLY ON BACK OF DISPLAY
NOTE: "X" dimensions should be equal.
WARNING
8 of 35
X
X
ISSUED: 02-25-11 SHEET #: 009-9049-5 06-16-14
Publicidad
