Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS AND CONNECTIONS
1.
SD Input
Connect your SD/MMC card in this slot to play
music with MP3 format.
2.
USB Input
Connect your USB devices to this slot to play
music with MP3 format.
3.
Media Player Buttons
Mode: Switches modes from Bluetooth, SD, USB.
Next / Volume+: Short press for plays the next
USB,SD or Bluetooth track. Press for 2 seconds
for increasing volume.
Play / Pause: Play/Pause the USB, SD, or
Bluetooth source.
Previous / Volume -: Short press for plays the
previous USB,SD or Bluetooth track. Press for 2
seconds for decreasing volume.
4.
Channel Volume
Adjust the level of the channel signal to the master
signal.
5.
Effect Volume
Adjust effect input signal level
6.
Bass
Adjust high low tone control from output signal.
7.
Treble
Adjust high tone control from output signal.
8.
Clip Indicator
The LED lights up when the input signal is driven too high. If this happens, reduce the channel signal.
9.
Channel 3/4 Volume
Adjust the level of the CD/Phone input or the MP3 player to the master signal.
10. Monitor Volume
Adjust the level monitor output signal.
11. Effect to main
Adjust effect input signal level to the master signal.
12. Subwoofer Volume
Adjust the volume of the subwoofer.
13. Master Volume
Adjust the overall output level of the sound system.
14. LED Indicator
Power: The blue LED lights up when console in powered on.
Limit: The LED lights up when the input signal is driven too
high. If this happens, reduce the master signal.
Level Indicator: Displays the signal of output in 5 segments.
15. Line/Mic Input Selector
Press this button for switch between line input and microphone signal.
Button pressed: Microphone signal.
Button not pressed: Line input signal.
16. HI-Z Selector
Press this button for guitar signal input. Press Line/Mic switch to microphone signal first, then press HI-Z button.
17. Combo Input
Combo connector for balanced microphone via XLR or unbalance line signal via 6.3mm ¼" Jack connector.
4
Publicidad
