Vonyx CDJ450 Double Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CAUTION LASER RADIATION!
This device is equipped with two Class 1 laser diodes. To ensure a safe operation do not remove any covers or try to
access the inside of the equipment. The inside of the device does not contain any parts which are subject to
maintenance. Maintenance must only be carried out by qualified staff.
CONTROLS AND CONNECTIONS
For a detailed and numbered illustration of the device please see end of this manual.
CD PLAYER AND MIXING CONSOLE:
1. EJECT BUTTON
Press to load or eject disk. Each press will open or close the disk tray.
NOTE: Disc holder will not open unless stop or pause button has been pushed first.
2. TIME BUTTON
Use this button to choose the time mode: elapsed time, remaining time or total remaining time.
3. SINGLE BUTTON
Press this button to switch between the SINGLE and CONTINUOUS play mode. The selected mode is indicated on the
LCD. In SINGLE mode, after each track, the unit stops the reading. In CONTINUOUS mode, the unit reads all tracks
and stops.
4. REPEAT BUTTON
Use this button to repeat one track or all the tracks on the CD.
5. PROG BUTTON
In STOP mode, you can program several tracks (20 tracks maximum):
- Press the STOP button to enter the stop mode.
- Press the PROG button to enter the program mode.
- Use the skip track buttons to choose the track you want to listen to, then press the PROG button to enter your
choice.
- Repeat the operation to select all the tracks you want to listen to.
- Press the PLAY/PAUSE button to start the playback.
6. FOLDER BUTTON
Allows you to navigate through folders in either USB or CD mode.
SEARCH ◄◄ AND ►► BUTTON
7.
Press to rewind or fast-forward through a track.
TRACK SEARCH I◄◄ AND ►►I BUTTON
8.
Select the previous or next track.
9. DSP / BRAKE
In play mode, push the BRAKE button first and then the PLAY/PAUSE button to slow the track to a halt.
Push the PLAY/PAUSE button again to cancel this feature.
10. DSP / REVERSE
Push the REVERSE button to play your track in reverse. Push the reverse button again to cancel this feature.
11. TRACK SELECT BUTTONS
Press this button to be able to switch between PITCH BEND, SCRATCH and SEARCH functions.
When the indicator LED is off, the jog can be used for PITCH BEND function. When the indicator LED is on, the jog
wheel can be used for scratching. When the indicator LED flashes, quick search forward and backwards is enabled.
3