Descargar Imprimir esta página

Glacier bay 67277W-8004 Guía De Instalación Y Cuidado página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation (continued)
2
Removing the quick connector
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.
Care and Cleaning
To clean, wipe down with a damp cloth and dry with a towel.
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks from the
handle.
The aerator has an
irregular or reduced
water ow.
The water will not shut off
completely.
There is leaking from the
sink drain at the base of
the sink.
Possible Cause
The bonnet nut has come loose and/or the
washer is dirty or damaged.
The aerator is dirty or mis- tted.
The cartridge is dirty or broken.
The sink has a rough or irregular surface.
Squeeze
1
9
Please contact 1-855-HD-GLACIER for further assistance.
2
Pull
down
1
Solution
Tighten the bonnet nut.
Clean or replace the washer.
This faucet features an easy
clean aerator. Gently rub your
ngers against the face of the
aerator to break away any debris
or build up.
Remove the handle to check
the cartridge.
Clean or replace.
Apply additional silicone sealant
to the beveled side of the drain
ange.
Retighten and test for leaks.
HOMEDEPOT.COM

Publicidad

loading