Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
* Please keep owner's manual for future reference.
*If you have opened the carton and removed all packages, please disregard STEP 1 and 2. See STEP
3 directly.
STEP 1. (1) Open the carton and turn it upside down, make sure the
4 pieces of the carton open up as below Figure 1.
(2) Lift off the carton carefully and be wary of the accessories inside
falling away. Take away the box containing lava rocks.(3) Take all the
packing materials away except for the polyfoam rounding the top of the
fire table. See Figure 1.
STEP 3.
(I) Check each part before using the product. Make sure
the gas supply system is turned "OFF" before assembling.
See Figure A.
(II) Put the gas tank in the metal stand. Make sure the
gas tank sits on the metal stand completely. See Figure
D. Turn the wing screw on the outer part of metal stand
clockwise to secure the gas tank tightly. See Figure E.
(III) Locate the battery, remove the plastic cover first.
Unscrew the rubber cap of the Electric Ignitor, place a AAA
battery into the battery case. Make sure the positive pole
("+") faces towards the cap. Screw the cap back to the
battery case tightly. See Figure B.
(IV) Place the lava rocks evenly in the firebowl pan on the top
of the fire table. See Figure C. DO NOT COVER THE
IGNITION SCREEN when placing the lava rocks into the
firebowl pan. Always keep Ignition Screen visible.
** Connect the Pressure-Regulating Valve to the gas tank.
See Figure F.
1) Turn the cylinder valve clockwise to close the gas supply
on the gas tank.
2) Screw regulator coupling clockwise by hand only. Make
sure it is fastened.
1
STEP 2. (1) Turn the fire table heads up on a flat
ground.
(2) Cut off the binding tape on the polyfoam and
remove all the polyfoam rounding the top of the fire
table.
(3) Cut off the tie fastened to the regulator at the
metal stand and set it free for installation to Propane
Tank. See Figure 2.
2
OFF
6
Publicidad
