Whittier Wood Furniture Swivel Barstool 134Wa Manual De Instrucciones página 4

Fig. 8
8. For added strength, screw a #8 x 1-5/8" Black
Screw (K) through each leg chuck into the
disc. The screws must be inserted at such an
angle so that they do not go through the
other side of the leg or top of the disc. See
Figure 8.
D
Fig. 9
TO ATTACH THE SWIVEL TO THE DISC:
9. The top of the swivel is marked "FRONT" for
your convenience. Center the Swivel (D) on
the Disc (B) lining up the screw holes in the
swivel with the indentation marks on the disc.
Remove the swivel and drill a 1/8" pilot hole,
1/2" deep into the center of each indentation
mark. Fasten the swivel to the disc with the
#12 x 1" Pan Head Screws (I). See Figure 9.
NOTE: A new swivel may appear frozen or
hard to turn. It can be loosened by twisting it
a little before assembly. Be sure to use a
towel or gloves to protect hands as the
edges of the swivel may be sharp.
Page 4 — 134Wa — 09/13
To insert screw at proper angle, the
screw head should be approximately
1/2" from the nearest surface when
starting the screw.
K
B
B
TO FINISH ASSEMBLING THE BARSTOOL:
10. Cover your work surface with a cloth or piece
of cardboard to protect the finished seat.
Place the seat upside down on the work
surface. Be sure the front of the swivel is
placed towards the front of the seat, Place
the leg assembly upside down on the bottom
of the seat and line up the holes in the swivel
with the pilot holes in the seat. Screw the
swivel into place through the access holes in
the disc with the #12 x 1" Pan Head Screws.
Turn the leg assembly until the other two sets
of holes line up with the access holes in the
disc and finish screwing the swivel down with
the #12 x 1" Pan Head Screws. SEE Figure 10.
KNOB
Fig. 11
FOR USE AS A COUNTERSTOOL:
11. To convert your barstool to a counterstool,
simply cut off the bottom portion of the leg,
above the knob, as shown in FIGURE 11.
This will adjust the seat height to 24-3/4".
Fig. 10
CUT HERE