Publicidad
Idiomas disponibles
Idiomas disponibles
5
MAINTENANCE
LUBRICATION
The machine should be cleaned and lubricated every eight (8) operation
hours. Retract the dies to lubricate.
Use a small brush to lubricate the cone shaped surfaces in the cylinder.
Better to lubricate sparingly and more often than seldom and excessively.
Without lubrication, the machine
looses power and you will damage the sliding surfaces.
Use only the lubrication recommended by us: Optimol viscogen 4.
CALIBRATION
If the actual crimping measurement differs too much from the set crimping
measurements then calibrate the machine.
1. Contract (press) the dies together completely.
2. Set the dial to - 0.2.
3. Loosen the side covers.
4. Loosen the locking nut (nr 1).
5. Turn the adjustment dial (nr 2) so that the end surface of the set screw
(A) align with the face of the ring.
6. Tighten the locking nut (nr 1).
7. Calibration is complete.
8. Check Repeat the procedure if the actual crimping measurement differs
from the set crimping measurement.
21 | English
Publicidad
