Oursson RF0480 Manual De Instrucciones página 14

Reversing the door, Pic D-4
Top hinge cover
1
Top hinge screw
2
Top hinge
3
Cabinet plug
4
Bottom hinge
5
Door handle plug
6
Bottom hinge screw
7
Leveling leg
8
1. Remove top hinge cover
which are below it. Then remove top hinge
2. Remove cabinet plugs
4
3. Remove the door.
4. Remove right and left leveling legs
5. Remove the bottom hinge
7
.
6. Install the bottom hinge
5
eling legs with bottom hinge screws
7. Install right and left leveling legs
holes below the refrigerator to fit the two levelling legs.
8. Install the door.
3
9. Install the top hinge on the other side with top hinge
screws 2 .
10. Install top cover above the top hinge and install
1
cabinet plugs
4
and door handle plug
side.
11. Adjust the leveling legs
8
Note: Don't tilt the appliance over 45° when revising the
door as possible damage to the sealed system may occur.
POSSIBLE PROBLEMS AND SOLUTIONS
Possible problems
Device isn't working.
Vibrating noise .
The temperature is not cold
enough
The compressor is operating for
a long period.
Frost accumulated on the rear
side of the device.
Please check the possible problems before contacting a service center.
14
1 2
and top hinge screws
3
.
6
and door handle plug .
8
.
and bottom hinge screws
5
on the other side of the lev-
7
.
8
. There are two
6
on the other
.
Possible causes
• There is no voltage in the mains.
• The cord is plugged incorrectly.
The device is in unstable position.
• The door is not closed firmly.
• Not enough ventilation
• Ambient temperature is too high.
• The door is opened too often or
remains open.
• There is hot or moisture food in
the device.
• High humidity of the
environment.
CLEANING AND MAINTENANCE, Рiс. F
• Unplug the device.
• Wash the inner parts of the device with a soft cloth and
clean water with a detergent, then wipe everything with
a cloth and clean water and wipe dry.
• Contamination of the door gasket can cause damage
to it, so regularly clean it with a soft cloth and a small
amount of neutral detergent.
• Outer surface of the device must be cleaned with a
slightly damp or dry cloth.
• Do not rub with detergent the informational sticker in-
side the device, because printed information can be
erased. The information is necessary for service.
• Do not spill water on the electrical components of
the device, as well as air vents because of the dan-
ger of electric shock.
TRANSPORTATION, Рiс. E
• Make sure there are no children or animals in the
device.
• Move and transport the device only in the un-
loaded condition.
• It is recommended to move and place the device
in two, Pic. E-1
• Pack the device before moving it.
• When moving do not grab or pull the door or door's
handle.
• When moving the device you cannot tilt it more than on
45 degrees. Protect the device from excessive vibration
and hits. Pic. E-2.
• Please transport the device packed and in vertical po-
sition. Improper transportation may result in injury and
damage of the device.
Solutions
• Turn on the device.
• Check the main and the plug. If they are
working, call the service center.
• Adjust the position of the device.
• Move it if necessary.
• Make sure the door is firmly closed.
• Clean the vents.
• Adjust the temperature of the room.
• Make sure the door is firmly closed.
• Do not place hot or unpacked products into the
device.
• Adjust the humidity in the room.