Publicidad
Maintenance & Adjustments
Adjustments
Storing the Hauler
The hauler can be folded up for storage purposes. To prepare the
hauler for storage, proceed as follows:
1.
Pull up on the tailgate latches and fold the tailgate down
into the bed.
2.
Push the levers on the front of the hauler, under the bed
floor and lower the front panel down into the bed.
3.
Fold the side panels down onto the bed until they snap
into the panel latches.
4.
Remove the clevis pin and cotter pin securing the tongue
assembly into the tongue bracket.
5.
Slide the tongue assembly out of the tongue bracket.
6.
Stand the hauler up on its front end. See Figure 6-1.
Figure 6-1
7.
Slide the tongue assembly into the opening on the hauler
support bracket as shown in Figure 6-1.
8.
Secure the tongue assembly in place with the clevis pin
and cotter pin as shown in the inset of Figure 6-1.
Making a Divider for the Hauler
Using a piece of 1⁄2" plywood, a divider can be constructed to
create two separate bins for the hauler.
The dimensions for this divider are 12" high x 32-1⁄2" long by 1⁄2"
thick. Carefully cut the plywood and install it into the hauler bed
as shown in Figure 6-2.
Figure 6-2
Maintenance
1.
Lubricate all the pivot points annually or as needed.
2.
Grease the wheels using the grease fitting on the wheels
annually or as needed. See Figure 6-3.
Figure 6-3
6
11
Publicidad
