Publicidad
Idiomas disponibles
Idiomas disponibles
Switching power supply/Battery charger
EN IEC 62368-1
The IPS24160G switching power supply/battery charger has been designed and
manufactured to the highest standards of quality, reliability and performance adopted
by INIM Electronics. INIM Electronics guarantees that the components selected for this
product will operate properly within their specifications when the environmental
conditions outside the enclosure comply with Class 3k5 (EN 60721-3-3).
The IPS12160G unit provides a regulated 27.6V and 4A maximum current by means of
the "+V" and "-V" terminals.
The outputs are overload, short-circuit and reverse polarity protected.
The unit can be equipped with an optional thermal probe (ProbeTH see the Inim
catalogue) which is capable of maintaining the battery charge current at the appropriate
level for efficient battery charging.
A
Mains input terminal board
B
Battery connector
C
Output terminal board
D
Output connector
E
Thermal probe connector
F
OC output connector
Serial port connector
G
(reserved)
H
I
Ground fault signalling jumper input
J
Anchor screw hole (Ø 3.25mm)
Technical characteristics
Mains supply voltage
Absorbed current
Output voltage
Operating output voltage
Battery shutdown tension
Maximum output ripple
Maximum out-
for external load
put current
for battery
recharge
Connectable battery
(or equivalent with case flame
class UL94-V2 or higher)
Unreplaceble protection fuse (F1)
Maximum internal resistance of
battery
Operating temperature
Isolation class
Dimensions (W x H x D)
Weight
IPS24160G
providing 160W @ 27.6V
AC Input
230V ~ 50/60 Hz
BAT-, BAT+
+V, -V
RTH, FAULT,
-V, +V, -V, +V
NTC
STATUS
SERIAL
LED indicators
230V~ (-15%/+10%)
50/60Hz
1.1A (max)
27.6V
from 18 to 27.6V
19V
1%
total
5.2A
4A
1.2A
2 x 12V – 17Ah
YUASA NP-12 FR
T 3.15A 250V
1 Ohm
from -5 to +40 °C
200 x 51 x 99 mm
0.8 Kg
J
(±1%)
J
I
F
D G
C
B
H
STATUS
F
GND OC2 OC1
E
J
I
A
J
+V
Publicidad
