SNOWJOE sunjoe 24V-PS8CMAX-LTE Manual Del Operador página 13

Operation
Starting and Stopping
1. Slide the battery into the battery compartment until it
clicks to lock it into position (Fig. 15).
Fig. 15
2. To turn the pole chain saw ON, push and hold the safety
lock switch (located on the handle) forward with your
thumb and then squeeze the On/Off trigger switch with
your fingers. Once the tool is running, you can release the
safety lock switch (Fig. 16).
Fig. 16
3. To turn the tool OFF, release the On/Off trigger switch
(Fig. 16).
Adjusting the Telescoping Pole
This machine is equipped with a telescoping pole which
provides up to 14 ft (4.3 m) of overhead reach. To adjust the
telescoping pole, follow the instructions below.
1. Disconnect the saw from the power supply by removing
the battery from the compartment.
2. Unclip the telescoping lock to release the pole. Extend the
pole to the desired length (Fig. 17).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the limb.
Battery
Safety lock
switch
On/Off trigger switch
Fig. 17
Pull
3. Lock the pole in position by closing the telescoping lock
(Fig. 18), and ensure that the pole is secured.
Fig. 18
m
WARNING!
Failure to lock the telescoping lock as
directed could result in personal injury.
Adjusting the Multi-Angle Head
The pole chain saw head can be rotated for different cutting
angles for 0º, 15º, and 30º (Fig. 19). Follow the below
instructions to adjust angles.
Fig. 19
1. Rotate the chain saw head to the desired cutting angle
while pressing the rotating buttons located on both sides
simultaneously (Fig. 20).
13
Pull
Telescoping lock
Telescoping lock
0º
15º
30º