Michelini Easy Jet A-8EJ Manual De Uso Y Mantenimiento página 18

EN
USE
PRELIMINARY FILLING
.Ensure that plug (5) is disconnected. Put the appliance on a stable surface, unscrew cap (8)
counter clockwise and use the funnel (9) delivered to pour in the quantity of water
desired. Close the boiler by firmly tightening the cap (8) clockwise.
MACHINE SWITCHING-ON - OPERATION WITH STEAM
. Insert plug (5) in a suitable socket, see safety standards. Press switch (1) for dryironing. Press
both switches (1 and 2) for steam-ironing. Switches light up when on. In the BOILER, turn on
switch 2 to heat the boiler and switch 1 to use cleaning accessories.
.In models equipped with iron pilot light (30), the iron temperature selected has been reached
when the pilot light switches off. To operate steam while ironing, press
iron button (13). For cleaning with the steamer, press the accessory steam button (28) on
the hose.
WATER TOP-UP IN THE BOILER
. Turn all switches (1, 2,28) off. Disconnect the plug (5) from power socket plug, carefully
rotate the cap (8) BY ONE REVOLUTION ONLY counter clockwise paying ATTENTION not to
direct the residual steam toward hands or body.
. Let the boiler discharge. Let the boiler cool down for a few minutes to prevent steam and
hot water drops from leaking, then use the funnel (9) available to slowly pour water in.
STEAM AND IRON TEMPERATURE
. When the pilot light switches on (3),the steam is ready. Steam ironing is only possible with
the highest temperatures (see table); really if steam is operated by button (13) at a low iron
temperature (for ex. silk), water drops get out of the plate, possibly spotting the fabrics.
Adjust iron temperature by rotating the knob (15). Before starting ironing (or cleaning with
steamer), address a steam jet to the air to let any water drops get out of the iron (or the
steamer accessories). During normal operation, the pilot light (3) shall routinely switch off,
steam can be operated in any case.
. To adjust steam intensity, act on the suitable knob (12), if available.
NOTES - To prevent the single-pipe (11) from scrubbing against the fabrics to be ironed,
while ironing, fasten it to the relevant rod (10) if available. Then, insert the rod into the hole
on the handle (7).