Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the fastening torque
1
1. Action mode changing ring 2. Adjusting ring
3. Graduation
4. Arrow
The fastening torque can be adjusted in 18 steps by turning the adjusting ring. Align the graduations with the arrow
on the tool body. You can get the minimum fastening torque at 1 and maximum torque at 18.
Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which
torque level is required for a particular application. The following shows the rough guide of the relationship between
the screw size and graduation.
Graduation
Machine screw
Wood
Soft wood
screw
(e.g. pine)
Hard wood
(e.g. lauan)
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
drill bit
Optional accessory
1
2
1. Sleeve
2. Close
Turn the sleeve counterclockwise to open the chuck
jaws. Place the driver bit/drill bit in the chuck as far
2
3
4
1
2
3
4
5
M4
–
–
3
3. Open
6
7
8
9
10
–
as it will go. Turn the sleeve clockwise to tighten the
chuck. To remove the driver bit/drill bit, turn the sleeve
counterclockwise.
Installing hook
1. Groove
2. Hook
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
11
12
13
14
15
M5
ɸ3.5 x 22
ɸ3.5 x 22
3. Screw
16
17
18
M6
ɸ4.1x 38
–
ɸ4.1x 38
1
2
3
ENGLISH
7
Publicidad
