SFaudio SFI-900 Manual De Instrucciones página 3

Introduction
Thank you for buying the SFI-900. Please read the manual thoroughly before bringing this device into
service. Make sure that the device was not damaged in transit. If the device is damaged, contact your dealer and
postpone installation of this device.
1.
Safety Instructions
Be careful during the installation : touching live wires can cause life-
threatening
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.
• This device falls under protection class I. It is therefore essential that the device be earthed. Have a qualified
person carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorized dealer replace it when
damaged.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug
only.
• Note that damage caused by user modifications to the device are not covered by the warranty.
• Keep the device away from children and unauthorized users.
• Do not aim the device at anyone.
• Use adapted smoke liquid only and don´t pour hot liquid into the tank.
• Make sure there is always enough liquid in the tank to keep the device from overheating.
2.
General Guidelines
• This device is designed for professional use on stage, in discos, theatres, etc. The SFI-900 should only be
used indoors with an alternating current of max.230VAC/50Hz.
• Smoke machines are not designed for permanent operation: regular operation breaks will prolong their lives.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat, dust and moisture. Ensure a minimum
distance of a 0.5m between the device and any nearby surface or passer-by.
• Use an appropriate safety cable to fix the device when mounted overhead.
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
USER MANUAL
3