Publicidad
Idiomas disponibles
Idiomas disponibles
Before assembly, take a few minutes to identify and become familiar with all the parts.
WARNING:
CLIMBING HAZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
Skimmer Installation
1. Set up your pool following the pool Owner's Manual instructions. Do NOT fill
water until the Filter Pump is properly installed. Locate the Skimmer Opening
on the pool wall.
Skimmer Opening
Pool Inlet
3. Turn counterclockwise to remove the Skimmer Seal Ring
that the Skimmer Gasket Rubber Seal
Return Fitting Installation
5. Assemble the Return Fitting
18
Inside Pool Wall
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.
SETUP INSTRUCTIONS
22
. Make sure
25
is in the correct position.
The protruding edge of the
Skimmer Canister
9
fits
in-between the two keys of
the Gasket
25
.
No gap here
as indicated below.
Make sure the Hose Clamps
11
seals tightly over both
the Return Hose
O-Rings
Extended operating days and hours during peak season requirements.
2. Slide open the Top Cover
4. Insert the threaded part of the Skimmer Canister
Opening, and then secure with the Skimmer Seal Ring
Inside Pool Wall
6. Now the Pump should be installed outside the pool wall as below.
12
and
10
.
To optimize water circulation,
twist the RF Diverter
that it faces up and away
from the Skimmer Opening.
OWNER'S MANUAL
5
and take out the parts inside.
Make sure that the pool liner is
placed tight on the Gasket
and is NOT trapped in the threads;
otherwise leaks may occur.
Outside Pool Wall
Inside Pool Wall
19
so
5
9
through the Skimmer
22
.
25
thread slots
9
Publicidad
