Powerworks PRL110 Manual Del Operario página 8

Installation
EN
Read the entire section before beginning installation. Installation affects mower capability.
Plan the installation carefully.
The following are the main tasks within the installation:
•
Planning layout and preparation
•
Installing and connecting the charging station
•
Connecting the power supply
•
Initial charging of the battery
•
Installing the boundary wire
•
Installing the guide wire
•
Calibrating and initial start up
Planning Layout and Preparation
Ensure that the following conditions exist in the operating area where the mower will be used:
•
The grass is shorter than 10 cm.
•
There are no stones, loose pieces of wood, wire, live mains cables, and other foreign objects.
•
The operating area is even and has no ditches, grooves, and steep slopes greater than 35%.
The following tools are required for installation, but not included:
•
Hammer/rubber mallet to drive the pegs into the ground
•
Combination pliers to cut the boundary wire
•
Polygrip to press the couplers together
•
Hex key, 6 mm for securing the charging station to ground
8
POWERWORKSTOOLS.COM