Publicidad
Idiomas disponibles
Idiomas disponibles
FOR INSTALLATION OF SKYMAXX LX PLUS ROOFLIGHT
WARNING!
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction.
CAUTION!
Disconnect main vehicle power before
connecting 12 volt DC power to the MAXXAIR ROOFLIGHT!
STEP 6
Insert the 12 volt DC power supply wires into the large
diameter hole in the interior flange, allowing 4 to 6 inches of
wire to hang out. Note: Red wire from the wall control and black
wire from the negative terminal.
STEP 7
Insert the ceiling flange into the opening, lining up the flanges.
STEP 8
Referring to the screw lengths in the table of STEP 2, use the
proper length screws depending on your roof thickness to
secure the ceiling flange to the rooftop flange, taking care not
to overtighten the screws to avoid cracking or deforming the
ceiling flange and rooftop flange.
STEP 9
Optional: Install the screws to secure the ceiling flange to the
caravan ceiling. If the ceiling flange does not lay flat to the
ceiling, you may want to install screws to prevent gapping.
STEP 10
Using the supplied wire nuts, connect the 12 volt DC power
supply wires to the LED light wires. Red wire from the wall
control to the red wire (pos) on the LED lights, and the black
wire from the negative terminal.
STEP 11
To assemble the Interior Shroud to the Ceiling Flange, line up
the flanges with the channels on the Ceiling Flange. Make sure
the power wires slide to the inside of the interior assembly and
do not become pinched or entangled. Secure in place by
pressing firmly on the Interior Shroud. This ensures that the
clips on the Interior Shroud will engage the channels on the
ceiling flange to lock it in place
This completes the installation of the MAXXAIR
SKYMAXX Plus ROOFLIGHT.
Publicidad
