Publicidad
! Affix the supplied cushions to the bottom of the unit to prevent
slipping.
WARNING
Store small parts out of the reach of children and
infants. If accidentally swallowed, contact a doctor
immediately.
Connections
! Be sure to turn off the power and unplug the power cord from the
power outlet whenever making or changing connections.
! Refer to the operating instructions for the component to be
connected.
Connecting cords
Connect the included speaker cord to the speakers.
1 Strip about 1 cm of the head of the included speaker
cord and twist and remove the exposed insulator.
After removing the insulator, thoroughly twist the core wires.
2 Connect the included speaker cord to the speaker
terminals on the LEFT and RIGHT sides.
3 Insert the core wires into the terminals while pressing
the claw on the speaker terminal.
Connect the speaker cord with the red line into the + terminal side (red)
and the speaker cord without the red line into the - terminal side (black).
＋
Red
−
Black
D41-6-4_A1_En
With the red line
! Install the speakers facing inward with a total angle of 60 degrees
from the listening position, 30 degrees for each of the left and right
speakers.
50 ° to 60 °
CAUTION
To promote proper cooling, please assure that sufficient spaceis pre-
served between the speakers and nearby walls or othercomponents
(minimum 15 cm or more above, behind, and toright and left sides of
each speaker). Leaving insufficient spacebetween the speaker and
walls or other components may lead torising interior temperatures,
leading to malfunction or damage.
! Connect the power cord after all the connections between devices
have been completed.
! Be sure to use the included power cord.
! Be careful with regard to the volume because the signals input to the
[INPUT 1] terminal and [INPUT 2] terminal are mixed.
CAUTION
! After connecting to the terminals, lightly pull the speaker cord to
make sure that heads of the speaker cord are securely connected
to the terminals. A loose connection might cause audio output to
be interrupted or noise to be output.
! When connecting the speaker cord, thoroughly twist the core
wires, and make sure that the core wires are not protruding out of
the speaker terminals. Core wires protruding out of the speaker
terminals may come into contact with the rear panel or with each
other. This may cause an excessive load to be placed on the ampli-
fier which results in operation stopping or a malfunction.
! If a mistake is made with the polarities (+, -) on the LEFT and
RIGHT sides when connecting the LEFT and RIGHT speaker cord,
normal stereo effect can no longer be obtained.
7
En
Publicidad
