Marshalltown TC24 Manual De Instrucciones página 5

3. After scoring, and without moving the tile, position
the handle so that the breaker foot is directly above
the tiles front edge (at the stop).
To cut an angle:
1. Adjust angle guide to desired angle and place the
guide against the tile.
3. Flip the breaker down and position slightly away
from the front edge of the tile.
WS2749revA
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
4. Apply increasing downward pressure on handle
until the tile snaps.
2. Carefully lower wheel until it makes contact with
tile and then apply consistent pressure while
scoring full length of the tile.
4. Apply increasing downward pressure on handle
until the tile snaps.
5 of 8