Fanimation SCULPTAIRE FP8511BS Manual De Instrucciones página 12

How to Assemble Your Light Kit or Cap
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2. Assemble the switch housing assembly to the
adaptor plate of the motor assembly using the two
key slots in the switch housing assembly. Replace
the third screw and secure all three screws.
(Figure 2)
3. Remove one of the three screws in the switch
housing assembly. Retain the screw for later and
slightly loosen the remaining two screws. (Figure 3)
4. Securely attach 9-pin connector from motor
assembly to wiring harness socket within light plate
assembly. (Figure 4)
WARNING
The color label on these two connectors must
correspond to each other.
5. Assemble the light plate assembly to the switch
housing assembly using the two key slots in the light
plate assembly. Replace the third screw and secure
all three screws. (Figure 5)
Motor
Assembly
Motor Assembly
Switch Housing
Assembly
Switch Housing
Assembly
Motor Assembly
Light Plate
Assembly
Switch Housing
Assembly
12
Figure 1
Figure 2
Figure 3
Figure 4
Light Plate
Assembly
Figure 5