Publicidad
Idiomas disponibles
Idiomas disponibles
T
ROUBLESHOOTING
Procedure 4: Check Amplifier if you experience Turn-on Pop.
1.
Disconnect input signal to amplifier and turn amplifier on and off.
2. If the noise is eliminated, connect the REMOTE lead of amplifier to source unit with a delay turn-on
module.
OR
1.
Use a different 12 Volt source for REMOTE lead of amplifier (i.e. battery direct).
2. If the noise is eliminated, use a relay to isolate the amplifier from noisy turn-on output.
Procedure 5: Check Amplifier if you experience excess Engine Noise.
1. Route all signal carrying wires (RCA, Speaker cables) away from power and ground wires.
OR
2. Bypass any and all electrical components between the stereo and the amplifier(s). Connect stereo
directly to input of amplifier. If noise goes away the unit being bypassed is the cause of the noise.
OR
3. Remove existing ground wires for all electrical components. Reground wires to different locations.
Verify that grounding location is clean, shiny metal free of paint, rust etc.
OR
4. Add secondary ground cable from negative battery terminal to the chassis metal or engine block of
vehicle.
OR
5.
Have alternator and battery load tested by your mechanic.Verify good working order of vehicle
electrical system including distributor, spark plugs, spark plug wires, voltage regulator etc.
S
PECIFICATIONS
MODEL-
Continuous Power Rating (RMS) -
Measured at 14.4 Battery Volts
4
Load Per Channel
2
Load Per Channel
1
Load Per Channel
Dimensions:
Height
Width
Length
Signal Voltage Adjustment Range
Protection
Equalization (Variable Punch Bass)
Input Impedance
Infrasonic Filter
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice
10
Amplifier Fuse Rating (Amp/Type)
T5001 bd
Battery Fuse Rating (Amp) External
(Not Supplied)
300 Watts x 1
400 Watts x 1
500 Watts x 1
2.3" (5.84cm)
12.8" (32.51cm)
13.6" (34.54cm)
case of very low impedance or shorted speaker wires.
Thermal switch shuts down the amplifier in case of overheating.
Signal-to-Noise Ratio
Crossover Slope
Crossover Frequency
Frequency Response
Slew Rate
IM Distortion (IHF)
Variable from 150mV to 4V (RCA Input)
Short circuit protection shut downs the amplifier in
Variable from 0dB to +18dB @ variable 35 to 70Hz
10k ohms
Selectable 12dB/Octave, -3dB @ 28Hz
(3) 40A / ATC
120A
>80dB A-weighted @ 2Vrms
12dB/octave Butterworth
variable from 35Hz to 250Hz
20Hz to 250Hz ±5dB
30 Volts/µS
<0.05%
Publicidad
