lauson AFF105 Manual De Instrucciones página 3

LAUSON
ASSEMBLY INSTRUCTIONS
1) Lay the base on a flat surface,
insert the foot into the base in
2 steps as shown in first
picture 1.
2) Mount the rear guard on the
fitter, matching the 2 turns of
the rear grille with the 2 shaft
on the fitter housing. Push
firmly so that the pins go
through the holes. Secure
firmly with the security screw.
3) Insert the blades onto the
shaft of the fitter and hold
them in place, screwing the
cap all the way in.
4) Check that the fan blades spin
freely without rubbing against
the security screw. If not, start
again from step 3
5) Mount the front guard by
clipping it on the rear guard
and make sure it is properly
fixed and maintained
OPERATING INSTRUCTIONS
This fan has three types of speed control.

Turn the device on by pushing the following buttons:
Weak
Middle
Strong

This fan is equipped oscillation function. You can switch on or off the oscillation
function, by pushing on the oscillation button.

You can change the angle of the fan by pushing or pulling the safety grill up or down.
STEP 1
Front
guard
0
1
2
3
STEP 2
Rear guard
Guard
security
screw
Fan
blades
Fan blades'
mounting screw
AFF105
3
EN