ZAMST JK-2 Instrucciones De Uso página 2

How to apply
• Before attaching this product, carefully read the "Precautions for use - Be sure to read this" section. Then follow the steps provided to ensure the
product is correctly attached.
• The steps below use the right leg for reference. Follow the same steps for the left leg.
1.
Unfasten all the hook-and-loop fasteners of the product.
Confirm the top/bottom, inside/outside, and front/back of
the product.
Tag
<Front of product>
<Back of product>
2.
With the size tag facing down, hold the product with both
hands and slide it up to your knee until the top edge of
the patella opening is approximately 2 cm (0.8 inches)
above the top of your patella.
Center line of
patella
Position of
patella
Tag
3.
Straighten your knee and fasten hook-and-loop fastener A.
Hook-and-loop
fastener A
Center line of
patella
Hook-
and-loop
fastener A
Reporting Obligation
If you have any complaints about the product, please contact your medical retailer directly. It is only necessary to notify the manufacturer and the competent authority of
the member state in the event of any serious incidents that could lead to a significant deterioration of health or to death. Serious incidents are defined in Article 2 No. 65 of
Regulation (EU) 2017/745 (MDR).
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
Place the side with the
size tag on the back of
the product face down
when applying it to your
knee.
Patella pad
Align the center of the
patella pad with the
center line of your patella
so that the pad encircles
your patella.
2 cm
(0.8 inches)
Align the jumper's pad
with the center line of
Position your patella. Make sure
of patella
that the jumper's pad
is under your patella
(patellar ligament).
Position of
jumper's pad
Fasten hook-and-loop
fastener A while pulling it
Position
diagonally downward so
of patella
that the bottom edge of
the patella opening fits
the bottom edge of your
patella.
4.
Fasten the understrap to create the required compression.
5.
Fasten the thigh strap to create the required
compression.
Thigh strap
6.
Straighten your knee and pull the product to eliminate
slack.
7.
Make sure that the product is not loose or out of place.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.
The product correctly fastened (right leg)
<Front view> <Side view>
Understrap
Refasten each hook-and-
loop fastener repeatedly
until appropriate
compression is created.
Pull up the slack on the
front and back of your
knee.
<Back view>